Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I'm looking to make a bridge controller between a legacy system consisting of GE DMC controller's and Siltron drives. I would like to connect a bridge controller via CBUS to DMCs. So I am looking for hardware compatible with C-BUS and it would be fantastic ifcodesys ran on such hardware.
Any ideas or suggestions are welcome.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Originally created by: rickj
I'm looking to make a bridge controller between a legacy system consisting of GE DMC controller's and Siltron drives. I would like to connect a bridge controller via CBUS to DMCs. So I am looking for hardware compatible with C-BUS and it would be fantastic ifcodesys ran on such hardware.
Any ideas or suggestions are welcome.