Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hello.
I want to connect the Beckhoff DeviceNet Slave EL6752-0010 via an Ethercat coupler EK1100 to the Ethercat master of Codesys V3.
I get the ethercat communication running, but the configuration of the DeviceNet via Ethercat doesn't seem to work properly.
The DeviceNet master isn't able to start the communication (device deactivated).
Via Twincat the configuration of the DeviceNet works. So the hardware setup is correct.
Can someone provide a demo of such a configuration or some more detailed configuration instructions.
A configuration with a few bytes in- and output in polling mode would be sufficient.
Regards
Thomas
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Originally created by: Thomas Wiesenthal
Hello.
I want to connect the Beckhoff DeviceNet Slave EL6752-0010 via an Ethercat coupler EK1100 to the Ethercat master of Codesys V3.
I get the ethercat communication running, but the configuration of the DeviceNet via Ethercat doesn't seem to work properly.
The DeviceNet master isn't able to start the communication (device deactivated).
Via Twincat the configuration of the DeviceNet works. So the hardware setup is correct.
Can someone provide a demo of such a configuration or some more detailed configuration instructions.
A configuration with a few bytes in- and output in polling mode would be sufficient.
Regards
Thomas
Hello Thomas,
hard to say, the device net support in CODESYS is obsolete (no or to few customers ask for it)
Therefore the EL6752 is not supported.
Grüße
Edwin