Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have CODESYS v3.5.9. Is it possible to connect UPS charger (787-870) to PLC (WAGO PFC200 750-8207) and read the parameters of UPS by serial interface RS 232 module (750-652)?
The serial interface module asks for parity, baud rate and stop bit,.... But there is no similar configurations about UPS in it's software configurator!!!
Thanks in advance
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi everyone
I have CODESYS v3.5.9. Is it possible to connect UPS charger (787-870) to PLC (WAGO PFC200 750-8207) and read the parameters of UPS by serial interface RS 232 module (750-652)?
The serial interface module asks for parity, baud rate and stop bit,.... But there is no similar configurations about UPS in it's software configurator!!!
Thanks in advance