Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I'm trying to get the acyclic communication working to a profibus slave but I can't figure out where to find all information to get the ID used for the function blocks below:
RALARM
RDIAG
RDREC
WRREC
Scope Name Type Initial Comment
Return ID DWORD
Input EN BOOL TRUE
MASTER BYTE ID of the DP system
SEGMENT BYTE Number of the DP segment
STATION BYTE Number of the DP-slave(station address)
SLOT BYTE Slot number
The station byte is the slave dp address but where do I find the values for the rest?
I'm running with the EL6731 Profibus master from Beckhoff, see configuration on the attached picture.
/Martin
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I'm trying to get the acyclic communication working to a profibus slave but I can't figure out where to find all information to get the ID used for the function blocks below:
RALARM
RDIAG
RDREC
WRREC
Scope Name Type Initial Comment
Return ID DWORD
Input EN BOOL TRUE
MASTER BYTE ID of the DP system
SEGMENT BYTE Number of the DP segment
STATION BYTE Number of the DP-slave(station address)
SLOT BYTE Slot number
The station byte is the slave dp address but where do I find the values for the rest?
I'm running with the EL6731 Profibus master from Beckhoff, see configuration on the attached picture.
/Martin