Author |
Message |
jamesbuniak
|
PostPosted: Tue Aug 23, 2016 5:59 pm |
|
Joined: Tue Jun 23, 2015 9:51 pm Posts: 3
|
I am trying to use an Ethernet field bus device communicating as a Modbus Master/Slave configuration and would like the end user to be able to change the IP address of the slave device.
This device will be going into locations where non programmers will be entering in the IP address.
Does anyone know if this is possible?
Field bus Name: Ethernet Vendor: 3S - Smart Software Solutions GmbH Categories: Ethernet Adapter, Ethernet Adapter, Ethernet Adapter Type: 110 ID: 0000 0002 Version: 3.5.7.0 Order Number: - Description: Ethernet Link.
Modbus Master Name: Modbus TCP Master Vendor: 3S - Smart Software Solutions GmbH Categories: Modbus TCP Master Type: 88 ID: 0000 0003 Version: 3.5.9.0 Order Number: - Description: A device that works as a Modbus Master on Ethernet.
Modbus Slave Name: Modbus TCP Slave Vendor: 3S - Smart Software Solutions GmbH Categories: Modbus TCP Slave Type: 89 ID: 0000 0005 Version: 3.5.7.0 Order Number: - Description: A generic Modbus device that is configured as Slave for a Modbus TCP Master. Configuration version: 3.5.3.0
Thank you,
|
|
Top |
|
 |