Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I am experiencing this issue for quite a long time and now it started to stress me out. Whenever i include in my codesys programme only one icon (of any format - tested with bmp, jpg, png) the icon causes some of the visualization elements disappearing.
I am using -> CODESYS V3.5 SP8 Patch 3 <- on Sontheim eControl micro PLC. The compiler doesn't throw any errors and also working logic is fine, but visualization looks pretty ugly because PLC starts to cut some of the elements and some are even disappearing. I don't know, did I forget to do any settings modifications in codesys or is this the PLC issue... I don't know. I am adding some images to show you my problems. I added only one icon (1kb) in programme and the problem is showing immediately.
Thanks for the answer in advance.
Silvester
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi!
I am experiencing this issue for quite a long time and now it started to stress me out. Whenever i include in my codesys programme only one icon (of any format - tested with bmp, jpg, png) the icon causes some of the visualization elements disappearing.
I am using -> CODESYS V3.5 SP8 Patch 3 <- on Sontheim eControl micro PLC. The compiler doesn't throw any errors and also working logic is fine, but visualization looks pretty ugly because PLC starts to cut some of the elements and some are even disappearing. I don't know, did I forget to do any settings modifications in codesys or is this the PLC issue... I don't know. I am adding some images to show you my problems. I added only one icon (1kb) in programme and the problem is showing immediately.
Thanks for the answer in advance.
Silvester