CODESYS - the IEC 61131-3 automation software

Welcome to the official CODESYS Forum by 3S-Smart Software Solutions GmbH | A member of the CODESYS Group
Deutsche Version English version russian version 
It is currently Sat Dec 07, 2019 3:54 pm

All times are UTC+01:00




Post new topic  Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Thu May 05, 2016 10:43 am 
Offline

Joined: Fri Apr 29, 2016 7:07 am
Posts: 7
Good morning,
I made a software in codesys, made the login (F8), than put it in run (F5).

Problem is that when I switch off the power to the plc and switch on again, the plc reboot, but seems that I have to reput the software in run condition in order to have the same result as when I'm connected with the pc.

Is there any parameter in codesys in order to have the sw downloaded always in running condition (even when it has switched off)?

Thank you.


Top
   
PostPosted: Fri May 06, 2016 4:55 am 
Offline

Joined: Fri Feb 07, 2014 7:21 am
Posts: 86
Hi,
create the bootapplication.
Regards
plcmax


You do not have the required permissions to view the files attached to this post.


Top
   
PostPosted: Mon May 09, 2016 3:01 pm 
Offline

Joined: Fri Apr 29, 2016 7:07 am
Posts: 7
Thank you very much!


plcmax wrote:
Hi,
create the bootapplication.
Regards
plcmax


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 3 posts ] 

All times are UTC+01:00


Who is online

Users browsing this forum: No registered users and 3 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited