Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I'm trying to implement Network Variables protocol for communication between my application and Wago controller.
Generally it works fine for me, I was using this doc: Network_Functionality_V23.pdf
However, there is one question: How should I generate "boot up request" which I need to send to controller after my aplication start?
This doc does not explain how this packet should be constructed ?
Is there come more detailed doc or an example ?
Best Regards
Marek
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi all
I'm trying to implement Network Variables protocol for communication between my application and Wago controller.
Generally it works fine for me, I was using this doc: Network_Functionality_V23.pdf
However, there is one question: How should I generate "boot up request" which I need to send to controller after my aplication start?
This doc does not explain how this packet should be constructed ?
Is there come more detailed doc or an example ?
Best Regards
Marek