CODESYS - the IEC 61131-3 automation software

Welcome to the official CODESYS Forum by 3S-Smart Software Solutions GmbH | A member of the CODESYS Group
Deutsche Version English version russian version 
It is currently Fri Nov 22, 2019 1:03 pm

All times are UTC+01:00




Post new topic  Reply to topic  [ 1 post ] 
Author Message
PostPosted: Wed Mar 02, 2016 5:27 pm 
Offline

Joined: Mon Jul 28, 2014 9:08 pm
Posts: 6
Using the ignition to toggle the states between ON,OFF,Low Power,Sleep. I am trying to configure a Wachendorff A3 to enter low power for 60 seconds after ignition is off. After 60 seconds the unit completely shutsdown. The unit enters the low power state which keeps the application running preventing the screen to reboot which takes 30 seconds.

I have two CAN open nodes that shutdown when the ignition is off. When the ignition is turned back on with in the 60 seconds the screen wakes up the visu starts up and the CAN nodes send their boot message. The problem is that the CAN manager will not restart the nodes. The stay in pre-op. How can I sent my application(CAN manager) to restart the slaves when there bootup message is sent.


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 1 post ] 

All times are UTC+01:00


Who is online

Users browsing this forum: LooijmansR and 6 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited