Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I used the "GetDateAndTime" function to read the current date and time but I get the time as one hour earlier than the real time.
Where does the PLC read the time from? How can I set it to read the real local time?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I used the "GetDateAndTime" function to read the current date and time but I get the time as one hour earlier than the real time.
Where does the PLC read the time from? How can I set it to read the real local time?
Hi Raz,
what does the example dateandtime from CODESYS Store report?
BR
Edwin
I used this example, I just don't understand how can I set the time zone to my local time.
It always give my the time as CET. I need it to be CET+1
hello Raz,
which plc are you using?
Guess this is a Setting in the OS.
BR
Edwin