Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I'm preparing for my new project. I've choosen the m238 modicon plc from schneider because it has integrated PTO output which i need for my servo drive.
Here is a problem. Does this plc supports a webvisu within a ide somachine. I haven't found anywhere on the net...
If not, how can be solved?
Or
Do you recomend me any other plc that have webvisu, codesys v3 and pulse train output.
Alex
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
as I know there are actually no Schneider PLCs that support web visualization. But with the release of SoMachine V4 the next months,
at least the new M241 supports web visualization and PTO.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello!
I'm preparing for my new project. I've choosen the m238 modicon plc from schneider because it has integrated PTO output which i need for my servo drive.
Here is a problem. Does this plc supports a webvisu within a ide somachine. I haven't found anywhere on the net...
If not, how can be solved?
Or
Do you recomend me any other plc that have webvisu, codesys v3 and pulse train output.
Alex
Hello,
as I know there are actually no Schneider PLCs that support web visualization. But with the release of SoMachine V4 the next months,
at least the new M241 supports web visualization and PTO.
Tnx for info, i was afraid of that answer... I will not take any schneider then...
Do you recomend me any other plc that have webvisu, codesys v3 and pulse train output.
Regards,
Alex