Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Is it possible to read/write the ESC (EtherCAT Slave Controller) registers using CoDeSys?
I, for instance, need to reset the "PDI Error Counter" (0x030D), which can only be done by the EtherCAT Master.
I would greatly appreciate any hints.
Best regards, Rudi
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Is it possible to read/write the ESC (EtherCAT Slave Controller) registers using CoDeSys?
I, for instance, need to reset the "PDI Error Counter" (0x030D), which can only be done by the EtherCAT Master.
I would greatly appreciate any hints.
Best regards, Rudi
I have the same question. Can anybody help me with that?
I found out, that some kind of virtual sync managers are related to this. But i cant configure the slave to get the ESC register values.
Hi,
hier mit diesen FB's
BR
Edwin