Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
By default CmpBlkDrvUdp is created for every ethernet interface.
For example, I have two interfaces 192.168.1.1 and 192.168.2.1.
But I want to bind CODESYS only to 192.168.1.1. Is it possible to enable CODESYS Control run only on certain ethernet interfaces?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
By default CmpBlkDrvUdp is created for every ethernet interface.
For example, I have two interfaces 192.168.1.1 and 192.168.2.1.
But I want to bind CODESYS only to 192.168.1.1. Is it possible to enable CODESYS Control run only on certain ethernet interfaces?