CODESYS Forge - CODESYS Forge / Talk / Engineering 🇬🇧: Simulation mode detection

Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Simulation mode detection

Forum: Engineering 🇬🇧

Creator: AndreyS

Created: 2013-12-13

Updated: 2013-12-13

AndreyS - 2013-12-13

Is it posible in IEC program to detect that it is running in IDE in simulation mode?

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.