Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
When I use the fucntion block MC_ProfilePosition, I encounter some problems。
The first one :how to input the varible belonging to the type of the MC_TP_REF。I don't know how to define it。such as
when we use the varible belonging to the type of the MC_CAM_ID, we use the the function block MC_CAMTableSelect to produce the structe type of MC_CAM_ID.
the second one:when I use the language of ST to programm,how to realize a fast input。 and in current,I key into the input varibles and output varibles one by one。the efficient of programming is very low。
hope your help,thanks very much!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
When I use the fucntion block MC_ProfilePosition, I encounter some problems。
The first one :how to input the varible belonging to the type of the MC_TP_REF。I don't know how to define it。such as
when we use the varible belonging to the type of the MC_CAM_ID, we use the the function block MC_CAMTableSelect to produce the structe type of MC_CAM_ID.
the second one:when I use the language of ST to programm,how to realize a fast input。 and in current,I key into the input varibles and output varibles one by one。the efficient of programming is very low。
hope your help,thanks very much!