CODESYS - the IEC 61131-3 automation software
https://forum.codesys.com/

To implement G-code
https://forum.codesys.com/viewtopic.php?f=11&t=5070
Page 1 of 1

Author:  conoscenza [ Mon Oct 29, 2012 10:35 pm ]
Post subject:  To implement G-code

Hi to all!

how to implement G-code into smc_interpolator/smc_geoinfo?

I should to use G92 (assign a positioning without movement), but my project is based on smc_interpolator/smc_geoinfo and not on DIN66025.

any suggestions?

thank you in advanced

Author:  conoscenza [ Wed Oct 31, 2012 9:41 pm ]
Post subject:  Re: To implement G-code

Answer:

If you want to implement some G-Functions in OUTQUEUE, which can be directly passed on to the Interpolator, you must run through Decoder, and you evaluate the variables into DecoderBuffer.

Cheers!

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/