Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
If you want to implement some G-Functions in OUTQUEUE, which can be directly passed on to the Interpolator, you must run through Decoder, and you evaluate the variables into DecoderBuffer.
Cheers!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi to all!
how to implement G-code into smc_interpolator/smc_geoinfo?
I should to use G92 (assign a positioning without movement), but my project is based on smc_interpolator/smc_geoinfo and not on DIN66025.
any suggestions?
thank you in advanced
Answer:
If you want to implement some G-Functions in OUTQUEUE, which can be directly passed on to the Interpolator, you must run through Decoder, and you evaluate the variables into DecoderBuffer.
Cheers!