CODESYS - the IEC 61131-3 automation software

Welcome to the official CODESYS Forum by 3S-Smart Software Solutions GmbH | A member of the CODESYS Group
Deutsche Version English version russian version 
It is currently Tue Oct 15, 2019 3:45 pm

All times are UTC+01:00




Post new topic  Reply to topic  [ 2 posts ] 
Author Message
 Post subject: To implement G-code
PostPosted: Mon Oct 29, 2012 10:35 pm 
Offline

Joined: Fri Oct 26, 2012 7:24 pm
Posts: 13
Hi to all!

how to implement G-code into smc_interpolator/smc_geoinfo?

I should to use G92 (assign a positioning without movement), but my project is based on smc_interpolator/smc_geoinfo and not on DIN66025.

any suggestions?

thank you in advanced


Top
   
 Post subject: Re: To implement G-code
PostPosted: Wed Oct 31, 2012 9:41 pm 
Offline

Joined: Fri Oct 26, 2012 7:24 pm
Posts: 13
Answer:

If you want to implement some G-Functions in OUTQUEUE, which can be directly passed on to the Interpolator, you must run through Decoder, and you evaluate the variables into DecoderBuffer.

Cheers!


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 2 posts ] 

All times are UTC+01:00


Who is online

Users browsing this forum: dFx and 11 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited