Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi
I try to use TCP to communicate with my HMI and transfer some data. I have successfully communicated and transmitted dozens of REAL type variables.
Now I want to link REAL and DINT together and use ChainBuffer, but it only transfers the content and length in hHead.
The following is the procedure:
I can use two or more TCP Servers to avoid this problem, but I still want to figure out what went wrong.
thanks.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi
I try to use TCP to communicate with my HMI and transfer some data. I have successfully communicated and transmitted dozens of REAL type variables.
Now I want to link REAL and DINT together and use ChainBuffer, but it only transfers the content and length in hHead.
The following is the procedure: