Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
When I add a second Ethernet/IP Adapter to my project the Consuming/Producing assemblies are 100 and 101, the same as for the first Ethernet/IP Adapter, and cannot be edited. Does the Ethernet/IP driver support more than one Ethernet/IP Adapter? I would like to use Connected messages from a ControlLogix to access more than 2 assemblies.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
When I add a second Ethernet/IP Adapter to my project the Consuming/Producing assemblies are 100 and 101, the same as for the first Ethernet/IP Adapter, and cannot be edited. Does the Ethernet/IP driver support more than one Ethernet/IP Adapter? I would like to use Connected messages from a ControlLogix to access more than 2 assemblies.