Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
i have a question to write SDOs to a CanOpen Slave.
Can somebody give me an example how I have to write SDOs from my plc program to the Hardware?
I have to change the SDOs several times during a process.
The structure of the Hardware is: -NetX_CANbus---CANopenManger-----SlaveModul (here the SDOs must be changed)
Thanks in advance.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello togehter,
i have a question to write SDOs to a CanOpen Slave.
Can somebody give me an example how I have to write SDOs from my plc program to the Hardware?
I have to change the SDOs several times during a process.
The structure of the Hardware is:
-NetX_CANbus---CANopenManger-----SlaveModul (here the SDOs must be changed)
Thanks in advance.
Hello,
there is an example:
https://store.codesys.com/canopen-example.html
Best Regards
plcmax