CODESYS - the IEC 61131-3 automation software
https://forum.codesys.com/

RS485 implementation
https://forum.codesys.com/viewtopic.php?f=1&t=9369
Page 1 of 1

Author:  Biggles [ Fri Dec 07, 2018 1:08 pm ]
Post subject:  RS485 implementation

Codesys V2.3.9.49 (Build NoV 17, 2015)
750-881 Controller
750-652 RS232/485 Serial Interface
Beka BA488C Serial Text Display

PLC_PRG in ST

Good Morning all,
I'm a newby to Codesys and have been tasked to establish communications from 750-652 (Master) to Beka BA488C (Slave) to send ASCII Text under BAKA protocol which is not MODBUS RTU.

I need to gain an understanding of:

What Libraries do I need to add to the project if at all
How to configure 750-652 as Master
What variables I need to declare in POU

If anyone has a code example in ST that demonstrates how the above can be achieved I would be most obliged for any assistance.

Please don't be offended if I test your patience with lots of potentially stupid questions whilst I learn.

Thank you.

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/