Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have used SP RT earlier but now I want to know how to use the PLCWinRT.When I create a new program and asked to select a target the PLCWinRT option does not show-up in the drop-down box.But I am able to start PLCWinRT from the start menu.Also, when I start 'Install Target' PLCWinRT is already installed.Is there a document explaining the procedure to use PLCWinRT?Thank you.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
I have used SP RT earlier but now I want to know how to use the PLCWinRT.When I create a new program and asked to select a target the PLCWinRT option does not show-up in the drop-down box.But I am able to start PLCWinRT from the start menu.Also, when I start 'Install Target' PLCWinRT is already installed.Is there a document explaining the procedure to use PLCWinRT?Thank you.
Check the directories that the target that was installed. You probably installed in some where else.