CODESYS - the IEC 61131-3 automation software

downgrading from version 3.5.10.x to 3.5.6.x
Page 1 of 1

Author:  irfanmirza [ Fri Jul 06, 2018 4:36 pm ]
Post subject:  downgrading from version 3.5.10.x to 3.5.6.x

I had IDE version installed on my machine and developed some applications with that version. Later, I installed IDE 3.5.10.x and this installation disturbed all my previous applications.

If I open older application (in IDE or in newer), I can not run the application anymore, I get some version mismatches with the runtime. This is because the CmpApp version 3.5.7 and higher have some new interfaces which were absent before.
Is there any way I can downgrade PLC project to use the older version of libraries?

Thanks & Regards

Author:  JennyBrune [ Sat Sep 01, 2018 4:14 am ]
Post subject:  Re: downgrading from version 3.5.10.x to 3.5.6.x

I don't think this is a wise decision but go for it if you must. Maybe you can first uninstall the recent version.

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited