Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I am currently working on some automated Tests with ABB Products ant the Automation Builder from ABB.
In my test I use V2 Codesys, which is also integrated in the Automation Builder of ABB. And i want to know if it is possible to read out the massages of Codesys V2 ether with python or cmd commands?
Out of the codesys help i tried this code:
communication=codesys23.create("PLC0","Application")communication.create_conf()communication.start()communication.execute('out open C:\message.txt')communication.execute('library add SysLibCom.lib')communication.execute('library add SysLibComSetCtrl.lib')communication.execute('library add SysLibEvent.lib')
But there is in Exception in line 4
Exception: The execution of a CoDeSys V2.3 command failed
And i don´t now where the Problem is.
I hope someone can help me with my problem.
Best Regards and have a nice week
Sebastian
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi everyone,
I am currently working on some automated Tests with ABB Products ant the Automation Builder from ABB.
In my test I use V2 Codesys, which is also integrated in the Automation Builder of ABB. And i want to know if it is possible to read out the massages of Codesys V2 ether with python or cmd commands?
Out of the codesys help i tried this code:
But there is in Exception in line 4
Exception: The execution of a CoDeSys V2.3 command failed
And i don´t now where the Problem is.
I hope someone can help me with my problem.
Best Regards and have a nice week
Sebastian