Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have a thermostat connected to network over ModBus TCP/IP protocol.
I am trying to read some data from that thermostat with no success.
Is there any good tutorial how to do that or can anyone help me?
SOLVED: In ModbusTCPSlave I/O Mapping menu i had wrong setting in "Γ€lways update variables" drop down manu. If you don't have any variables in program it has to be set on "Enable 2 (Always in bus cycle task)"
Thanks,
Jan
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi everyone,
I have a thermostat connected to network over ModBus TCP/IP protocol.
I am trying to read some data from that thermostat with no success.
Is there any good tutorial how to do that or can anyone help me?
SOLVED: In ModbusTCPSlave I/O Mapping menu i had wrong setting in "Γ€lways update variables" drop down manu. If you don't have any variables in program it has to be set on "Enable 2 (Always in bus cycle task)"
Thanks,
Jan