CODESYS - the IEC 61131-3 automation software
https://forum.codesys.com/

Inverse PID Function Block
https://forum.codesys.com/viewtopic.php?f=1&t=6977
Page 1 of 1

Author:  loops1988 [ Fri Jun 03, 2016 8:05 am ]
Post subject:  Inverse PID Function Block

Dear All,
As titled, may i know how to make PID function works in inverse mode? I would like to make a PID blower control where the set value is wind pressure. In normal mode, blower speed need faster to make higher pressure. But when i select reverse mode, blower speed need slower to make higher pressure. In Tia portal , there is a bit for reverse mode. So i wonder whether reverse mode is available in CoDeSys or not. I had been searched in internet about the method but no result. Hope you all can help me about this. Thank you

Author:  shooter [ Sun Jun 05, 2016 8:29 pm ]
Post subject:  Re: Inverse PID Function Block

what PID function is used.
when you make the P action negative it will work.

This is standard theory.

Page 1 of 1 All times are UTC+01:00
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/