Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I've defined a watch list which I use to load the value needed for the elements in a recipe. At the beginning I need to load the watch list in order to have the value loaded and ready to use by the controller. However I want to reduce the job for the operator as much as I can. I was wondering if there is any way that by clicking at 'Start', the watch list loads automatically, without having the operator to navigate through the folders and pick the watch list to load.
Appreciate your help.
Regards,
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello experts,
I've defined a watch list which I use to load the value needed for the elements in a recipe. At the beginning I need to load the watch list in order to have the value loaded and ready to use by the controller. However I want to reduce the job for the operator as much as I can. I was wondering if there is any way that by clicking at 'Start', the watch list loads automatically, without having the operator to navigate through the folders and pick the watch list to load.
Appreciate your help.
Regards,