Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have set up a CR1082 (ifm PDM LCD display) and start to upload a simple visualization program on it.
The ping command works ok.
The simulation mode is fine
But when I try to login on the PDM, shows me "Communication Error (#0) Logout Performed"
Can some body advise me how to solve this
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I have set up a CR1082 (ifm PDM LCD display) and start to upload a simple visualization program on it.
The ping command works ok.
The simulation mode is fine
But when I try to login on the PDM, shows me "Communication Error (#0) Logout Performed"
Can some body advise me how to solve this
try to set your computer to address close to this one 192.168.82.245
the address in the software communications should be 192.168.82.247