Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Although all IXXAT products support the VCI driver we can't seem to get CoDeSys to connect with the PC104 "PC103" CAN card. Is CoDeSys compatible with this card? I can connect to the CAN bus using IXXATs' MINmon but not CoDeSys. Also if I am using a dual CAN card there is no setting via the CoDeSys communications parameters to select which port to use. I would assume if it is compatible it will default to port 1 only.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Although all IXXAT products support the VCI driver we can't seem to get CoDeSys to connect with the PC104 "PC103" CAN card. Is CoDeSys compatible with this card? I can connect to the CAN bus using IXXATs' MINmon but not CoDeSys. Also if I am using a dual CAN card there is no setting via the CoDeSys communications parameters to select which port to use. I would assume if it is compatible it will default to port 1 only.