Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have a problem establishing communication through the ethernet port after the communication between CoDeSys and the hardware is lost. I have noticed this on two similar occasions. In both cases the communication as succesfully been established, lost/disconnected, and without changing communication parameters, unable to be established again. It looks like this happens with only some PCs, not all.
Is there a setting that I am unaware of?
Thanks,
Tom
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Originally created by: Tomasz Wisniowski
Hello,
I have a problem establishing communication through the ethernet port after the communication between CoDeSys and the hardware is lost. I have noticed this on two similar occasions. In both cases the communication as succesfully been established, lost/disconnected, and without changing communication parameters, unable to be established again. It looks like this happens with only some PCs, not all.
Is there a setting that I am unaware of?
Thanks,
Tom