Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Does anyone have experience with Baumer MSAA servo drives ideally in Wago eCockpit?
When the nodes start up they go in pre op mode, but then when I set the CAN manager to auto start or send an NMT to start the node, the drive seems to reset after a very short period (few seconds). Any idea why a CAN drive would do that?
Kind Regards
Heinz
Sent from my SM-G935F using Tapatalk
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Same setting is available, I can now write and read SDOs and I receive the TPDOs.
Unfortunately the drive doesn't accept a new setpoint. It returns OK but when I read the target position back it stays on a certain value.
Hit another brick wall.
Sent from my SM-G935F using Tapatalk
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
Does anyone have experience with Baumer MSAA servo drives ideally in Wago eCockpit?
When the nodes start up they go in pre op mode, but then when I set the CAN manager to auto start or send an NMT to start the node, the drive seems to reset after a very short period (few seconds). Any idea why a CAN drive would do that?
Kind Regards
Heinz
Sent from my SM-G935F using Tapatalk
Hello,
I'm not sure which options are available on eCockbit but I would play
with These Settings here:(screenshot)
BR
Edwin
Same setting is available, I can now write and read SDOs and I receive the TPDOs.
Unfortunately the drive doesn't accept a new setpoint. It returns OK but when I read the target position back it stays on a certain value.
Hit another brick wall.
Sent from my SM-G935F using Tapatalk