Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I have a new device that use 3.5.9.2. It is fully licensed and operational. I have a issue with the TSC1 message not sending the request engine speed. I can see the message on the CAN bus but bytes 2 and 3 are always zero when I am writing 900 to the request engine speed.
The J1939 manager and ecu versions are 3.5.9.0. On the older device with 3.5.3.5 the TSC1 message transmits as expected. Is there something that would prevent Codesys from allowing the bytes to populate?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I have a new device that use 3.5.9.2. It is fully licensed and operational. I have a issue with the TSC1 message not sending the request engine speed. I can see the message on the CAN bus but bytes 2 and 3 are always zero when I am writing 900 to the request engine speed.
The J1939 manager and ecu versions are 3.5.9.0. On the older device with 3.5.3.5 the TSC1 message transmits as expected. Is there something that would prevent Codesys from allowing the bytes to populate?
hi,
guess this will be solved to 3.5.10.40 release.
BR
Edwin