Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hello,
trying to setup the Beckhoff Stepper Motor Terminal EL7031.
I already could ad the terminal itself to the EK1814 Ethercat coupler but i'm missing the "Drive" see picture "CodesysSoftmotion2.gif".
There was annother thread where the TO already had this drive see "CodesysSoftmotion.gif".
How do i add this driver? Has this somthing to do with the version?
Codesys version 3.5.9.2
Thanks to all
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
trying to setup the Beckhoff Stepper Motor Terminal EL7031.
I already could ad the terminal itself to the EK1814 Ethercat coupler but i'm missing the "Drive" see picture "CodesysSoftmotion2.gif".
There was annother thread where the TO already had this drive see "CodesysSoftmotion.gif".
How do i add this driver? Has this somthing to do with the version?
Codesys version 3.5.9.2
Thanks to all