Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
hello m trying to load visualization on eaton xv-112. codesys gives error : communication error(#0) logout performed.
target selected is same as version loaded on display(XV-1xx-v2.3.9 SP3). though it shows demo in codesys in front of target.
please help
thanks in advance.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
it says clearly there is no communication so go to online, find just under simulation mode the communication parameters.
It is possible you will need new firmware, this depends on the version of the software you are running.
for firmware contact the dealer of the hardware
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
hello,
hello m trying to load visualization on eaton xv-112. codesys gives error : communication error(#0) logout performed.
target selected is same as version loaded on display(XV-1xx-v2.3.9 SP3). though it shows demo in codesys in front of target.
please help
thanks in advance.
it says clearly there is no communication so go to online, find just under simulation mode the communication parameters.
It is possible you will need new firmware, this depends on the version of the software you are running.
for firmware contact the dealer of the hardware