CODESYS - the IEC 61131-3 automation software

Welcome to the official CODESYS Forum
Deutsche Version English version russian version 
It is currently Fri May 26, 2017 8:27 am

All times are UTC+01:00




Post new topic  Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Tue Dec 13, 2016 5:43 pm 
Offline

Joined: Mon Nov 28, 2016 2:45 pm
Posts: 18
Hello together,
I try to connect a Beaglebone Black with CANBus. So i build a Beaglebone Cape for CANBus (you see it in picture):
Attachment:
DIY Schematic.jpg

After that, i followed the instruction of this link: http://www.thomas-wedemeyer.de/beaglebo ... ython.html until the CAN test part (because it doesnt work for me).

And now the Problem: If i try to test the bus with "./cansend can0" nothing happens. So i have measure P9 Pin24 (UART1 TXD) againgst ground and the level still stay at 3,1 V (P.S. i measure with a PicoScope).

Now the question is: what did i do wrong ? Or can there be an other mistake ?

Thanks in advance.

Regards

Hummek


You do not have the required permissions to view the files attached to this post.


Top
   
PostPosted: Tue Dec 13, 2016 7:14 pm 
Offline
Site Admin

Joined: Mon Sep 05, 2005 9:42 am
Posts: 1936
Hi,
using other can capes you need to enable them by:

'For using a CAN cape add following line to /boot/uEnv.txt:
cape_enable=bone_capemgr.enable_partno=BB-CAN1'

Maybe this helps or at least you know what to 'google' for.

BR
Edwin


Top
   
Display posts from previous:  Sort by  
Post new topic  Reply to topic  [ 2 posts ] 

All times are UTC+01:00


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Limited