Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

New starter Pi HMI

lozzer65
2017-05-16
2017-05-17
  • lozzer65 - 2017-05-16

    Hi

    I wanted to produce a simple HMI program on a PI 3 with a 7" touch screen on it. I need this to pull and push data from/to the HMI from a Siemens s7-315 that has an ethernet card Lean 1 card on the rack. Can someone point me in the direction of how I can get the data to and from this PLC to the RPI 3 with codesys HMI on it.

    Thanks for any assistance.

     
  • eschwellinger

    eschwellinger - 2017-05-16

    Hi,
    the Pi3 could act as Profinet Controller or Profinet Device...!
    This could be the communication between S7 and CODSYS PI.

    BR
    Edwin

     
  • lozzer65 - 2017-05-16

    Thanks for the reply. Could you direct me to some specific instructions for this to get me started on how to set this up.

     
  • eschwellinger

    eschwellinger - 2017-05-17

    Hi,
    I would give this example here atry, both sides are in PN Controller and PN Device.

    l viewtopic.php?f=23&t=6247 l

    BR
    Edwin

    IMG: PN.jpg

     

Log in to post a comment.