Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi All,
I have done various tests with ethercat on the raspberry Pi and codesys, including virtual drives etc.
However I would like to ask how to use a Beckhoff Ax5000 series drive and Am8032 Motor.
I have installed the Device repository and scanned the system and found the drive unit.
But at this point I am stuck, the ethercat does't run on the servo drive and I am not sure how to tell codesys the motor type.
Any pointers would be a great help thanks.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
you need to do two things for this:
1. Use a rt_preempt patched Linux Kernel/ SD Image on the PI
2. You need to have/use Twincat to export the SDO startup parameter (which contains drive and motorconfiguration) set them up in twincat / Export them as XML file and import them in CODESYS
see screenshot.
BR
Edwin
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi All,
I have done various tests with ethercat on the raspberry Pi and codesys, including virtual drives etc.
However I would like to ask how to use a Beckhoff Ax5000 series drive and Am8032 Motor.
I have installed the Device repository and scanned the system and found the drive unit.
But at this point I am stuck, the ethercat does't run on the servo drive and I am not sure how to tell codesys the motor type.
Any pointers would be a great help thanks.
Hi,
you need to do two things for this:
1. Use a rt_preempt patched Linux Kernel/ SD Image on the PI
2. You need to have/use Twincat to export the SDO startup parameter (which contains drive and motorconfiguration) set them up in twincat / Export them as XML file and import them in CODESYS
see screenshot.
BR
Edwin
Thanks Edwin However I didn't see a screen shot suggested in your post