Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Once again, hopefully last time, I've an issue with a part of my unipi. The Analog Output, who is much more an PWM output that Analog Output. I'm trying to output but what so ever I do there is no difference and unipi does not respond to any help message I sent.
I know that the wiring is ok.
I use 1-wire and it work,
Digital Input work
Relay output work
Analog In work
The analog out is correctly wired.
I assume that the value to is beetween 0-10 because this is a REAL value and the unit is V so, I think that's mean Volt.
Is there anything to do to enable PWM? basicly I thought that Setup script was the only one setup to do but into the setup script there is nothing related to PWM.
I need help plz.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
Once again, hopefully last time, I've an issue with a part of my unipi. The Analog Output, who is much more an PWM output that Analog Output. I'm trying to output but what so ever I do there is no difference and unipi does not respond to any help message I sent.
I know that the wiring is ok.
I use 1-wire and it work,
Digital Input work
Relay output work
Analog In work
The analog out is correctly wired.
I assume that the value to is beetween 0-10 because this is a REAL value and the unit is V so, I think that's mean Volt.
Is there anything to do to enable PWM? basicly I thought that Setup script was the only one setup to do but into the setup script there is nothing related to PWM.
I need help plz.
please delete this post. After many check, I found a code 12 error. the problem was 12'' behind the keyboard.