Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Hi,
how can I change addressing in CoDeSys to run the board i2c espansion card of unipi emo r8?
Addressing the card is configured at the time in 21 Hex or 33 Dec
Thank you, Alberto
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
how can I change addressing in CoDeSys to run the board i2c espansion card of unipi emo r8?
Addressing the card is configured at the time in 21 Hex or 33 Dec
Thank you, Alberto
Nothing ?