Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
When jumping between text fields using the arrow keys the entire field becomes highlighted. To change only a portion of text, you have to then double click the mouse to drop the selection and just get cursor in edit mode.
This is very irritating as it is much faster to only working with keyboard.
Is there any way to get the cursor inside the text field for editing without mark the whole text? In other system its usually F2, SPACE or ENTER.
Regards
Johan
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
yes there is use home key and end key
home gets you to the start of the variable and end gets you to ...... the end
F2 is used to open an assist to variable and functions etc.
and Enter gets you to the next one
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
When jumping between text fields using the arrow keys the entire field becomes highlighted. To change only a portion of text, you have to then double click the mouse to drop the selection and just get cursor in edit mode.
This is very irritating as it is much faster to only working with keyboard.
Is there any way to get the cursor inside the text field for editing without mark the whole text? In other system its usually F2, SPACE or ENTER.
Regards
Johan
yes there is use home key and end key
home gets you to the start of the variable and end gets you to ...... the end
F2 is used to open an assist to variable and functions etc.
and Enter gets you to the next one
SOLVED
Thanks, this will make may day.