Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Steffen_R. hat geschrieben:
How can I create a submodule and add it in a plugged in Profinet slave?
I'm not sure what you mean with "create a submodule".
If you want to add a module below your Profinet slave you just have to use the method but also specify the module ID parameter.
There are some devices which have so called slots. For slots you use the method of the slot object instead of of the parent device object.
BR
Martin
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Anonymous
-
2017-03-06
Originally created by: Steffen_R.
Hi Martin,
I've got it so far. Thank you for that. But the problem I mentioned i my other thread still exists. After adding everything i go online und run the application. But there are still connection(?) problems....
Then i have to stop and logout, open the et200s treeobject, go online again and it runs.
I recognized that before i do that, the hostparameter id=1025 Name=slaveoptions is missing...
I tried it with disable and enable the device but nothing works...
Is there something i can do??
Thank you
Steffen
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Steffen_R. hat geschrieben:
But the problem I mentioned i my other thread still exists. After adding everything i go online und run the application. But there are still connection(?) problems....
That has nothing to do with the topic so please don't mix them.
BR
Martin
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Anonymous
-
2017-03-06
Originally created by: Steffen_R.
I'm sorry
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Originally created by: Steffen_R.
Hi,
How can I create a submodule and add it in a plugged in Profinet slave?
Steffen_R.
Hi Steffen_R.
I'm not sure what you mean with "create a submodule".
If you want to add a module below your Profinet slave you just have to use the method but also specify the module ID parameter.
There are some devices which have so called slots. For slots you use the method of the slot object instead of of the parent device object.
BR
Martin
Originally created by: Steffen_R.
Hi Martin,
I've got it so far. Thank you for that. But the problem I mentioned i my other thread still exists. After adding everything i go online und run the application. But there are still connection(?) problems....
Then i have to stop and logout, open the et200s treeobject, go online again and it runs.
I recognized that before i do that, the hostparameter id=1025 Name=slaveoptions is missing...
I tried it with disable and enable the device but nothing works...
Is there something i can do??
Thank you
Steffen
Hi Steffen.
That has nothing to do with the topic so please don't mix them.
BR
Martin
Originally created by: Steffen_R.
I'm sorry