Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched. Close

Export code to XML Error

Keithang
2017-05-12
2017-12-13
  • Keithang - 2017-05-12

    Hi Guys,

    When I export code written in CodeSyS 3.5 SP10, I get the following error:

    The Type: "_3S.CoDeSys.NWLObject.BoxTreeTerminator' is not supported.

    If I delete the network (Ladder Logic) it exports fine, but defeats the purpose wouldn't you say...lol

     
  • r.evbatyrov - 2017-05-17

    Hi Keithang,

    can you identify the network that produces this exception?
    Please post a screenshot of it here, probably we will found some workaround.

    Regards,
    Roman

     
  • r.evbatyrov - 2017-12-13

    Hi Keithang,

    there is a simple workaround for your case: add a TRUE contact just after the powerrail.
    This will eliminate the necessity of yet unsupported terminator element which exists between powerrail and branch point.

    Regards
    Roman

     

Log in to post a comment.