Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
Is it possible to use the j1939ecu module to read multipacket DM1 messages? I tried added another spn_1 signal to the pgn but does not seem to read the multipacket.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Is it possible to use the j1939ecu module to read multipacket DM1 messages? I tried added another spn_1 signal to the pgn but does not seem to read the multipacket.