Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I'm trying to use the Project > Document function, but can't find any way to change the font/tab size to allow a single line of code to print on a single print line.
At present it prints over two making the listing hard to follow as well as taking twice as much paper.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
PJE hat geschrieben:
I'm trying to use the Project > Document function, but can't find any way to change the font/tab size to allow a single line of code to print on a single print line.
At present it prints over two making the listing hard to follow as well as taking twice as much paper.
Open the Project Settings, select "Page Setup" and open the tab "Document".
BR
Martin
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I'm trying to use the Project > Document function, but can't find any way to change the font/tab size to allow a single line of code to print on a single print line.
At present it prints over two making the listing hard to follow as well as taking twice as much paper.
Hi PJE.
Open the Project Settings, select "Page Setup" and open the tab "Document".
BR
Martin
Hi,
All I can seem to adjust are the heading levels and the table of contents, not the actual listing...
I'm using the Eaton XSOFT 3.5.8 version of the editor.
PJE