Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
In order to use a Wago CANopen 750-337 module I've created a new device using the device repository and loaded the eds file provided by Wago. If I try to set the cobid (in the pdos section) for rxpdo5 to 0x780+nodeid this is not allowed and the valid range only appears to be 0x180-0x57F, 0x681-0x6DF. Why is this not allowed? 0x780 seems to be a valid function code.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
In order to use a Wago CANopen 750-337 module I've created a new device using the device repository and loaded the eds file provided by Wago. If I try to set the cobid (in the pdos section) for rxpdo5 to 0x780+nodeid this is not allowed and the valid range only appears to be 0x180-0x57F, 0x681-0x6DF. Why is this not allowed? 0x780 seems to be a valid function code.