Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
I'm trying to write a sequence in SFC, but I want to use IEC-Steps instead of the simplified version. When I toggle the IEC-Steps on, I'm told that I'm missing the "IEC-Library", further digging through manuals found that specifically I'm missing this one "lecsfc.lib".
Does anyone know where I can obtain this, as all I can find is information on Wago's and all sorts, nowhere to actually get a hold of this library.
Thanks
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi All,
I'm trying to write a sequence in SFC, but I want to use IEC-Steps instead of the simplified version. When I toggle the IEC-Steps on, I'm told that I'm missing the "IEC-Library", further digging through manuals found that specifically I'm missing this one "lecsfc.lib".
Does anyone know where I can obtain this, as all I can find is information on Wago's and all sorts, nowhere to actually get a hold of this library.
Thanks
give me email adress and PLC type and will send it to you (or the wago will)